点击QQ请与我交谈!
产品编号检索/替代型号参数查询
先进光半导体
  • ------热电堆温度传感器
    TO46 封装
    TO39 封装
  • ------碳化硅及晶圆
    碳化硅光耦继电器
    碳化硅MOS
    碳化硅SBD
    碳化硅晶圆
  • ------通用型光耦继电器
  • 1路常开及2路常开1a2a
    0~80V
    0~180mA
    200~900mA
    1000~2000mA
    2100~5000mA
    100~250V
    0~180mA
    200~900mA
    1000~2000mA
    2100~5000mA
    300~400V
    0~90mA
    100~180mA
    200~500mA
    600~800V
    0~90mA
    100~180mA
    200~600mA
    1000~1500V
    20~100mA
  • 1路常闭及2路常闭1b2b
    0~80V
    0~180mA
    200~900mA
    1000~2000mA
    2100~5000mA
    100~250V
    0~180mA
    200~900mA
    1000~2000mA
    2100~5000mA
    300~400V
    0~90mA
    100~180mA
    200~600mA
    600~800V
    0~90mA
    100~180mA
    200~600mA
  • 常开常闭双路触点1a1b
    0~60V
    100~500mA
    1000~2000mA
    200~250V
    100~250mA
    350~400V
    50~90mA
    100~200mA
    600V
  • ------栅级驱动光耦
    APPL-P314
    APPL-W314
    APPL-P341
    APPL-W341
    APPL-P343
    APPL-W343
    APPL-P480
    APPL-W480
    APPL-4800
  • ------高速通信光耦
    APPL-2501/APPL-2531
    APPL-2601/APPL-2631
    APPL-0601/APPL-0631
    APPL-M61L/APPL-M75L
    APPL-4502/03/04
  • ------固态继电器光耦
    APH0213/0223
    APH1213/1223
    APH2213/2223
    APH3213/3223
    APH4213/4223
  • ------常用型光耦
    光伏光耦
    ALP-190/ALP-191
    APPL-3902/APPL-3904/APPL-3905/APPL-3906
    APV1121/APV2221
    可控硅光耦
    MOC3020/21/22/23
    MOC3041/42/43
    MOC3051/52/53
    MOC3061/62/63
    MOC3081/82/83
    晶体管光耦
    AFH615A-4
    AFH6156-4
    AFH628A-3
    AFH6286-3
    4N25/4N35
    MOSFET驱动光耦
    APV1122
    APV1123
    APV1124
    APV1125
    光纤耦合器
    光耦系列晶圆
产品详情

APW210EH替换AQW210EH         SSR PHOTO RELAY SPST-NO (2A)         0V ~ 350V 120mA

 
产品详情
关联产品(代替)
产品应用
文档下载
APS PN APW210EH Series Photo MOS Solid State Relays
Termination Style PC Pin Description SSR RELAY SPST-NO 120MA 0-350V
Circuit SPST-NO Number of Circuit (1 Form A)x2
Output Type AC, DC Voltage-Input 1.14VDC
Voltage-Load 0V ~ 350V VOFF (Max)(V) 350V
Load Current 120mA On-State Resistance (Max) 25 Ohms
Mounting Type Through Hole Packaging Tube
Package 8-DIP Package/Case 0.300, 7.62mm width
Package/Size 9.86x6.4x3.2mm Topr (Min~Max) (degC) ‘-40~85 ℃

光耦继电器应用

4.jpg

1.Power storage system蓄电系统

2.Smart meters‍智能电表

3.Automatic meter reading自动抄表

4.Telecommunications‍ ‍ TELECOM电信设备

5.Instrumentation测量仪器

6.Medical equipment医疗设备

7.Communications equipment通信设备

8.Programmable controllerPC设备

9.Security Equipment防范・防灾机器

10.OA equipmentOA设备

11.If you are a user experiencing difficulty with solid-state relays and triacs:计时器

12.‍Microprocessor System I/O Board 在计算机系统I/O板中的应用


1.For Charge and Discharge 充放电用途

AP- Series SSR (APS Photo Relays) is used to switch charge and discharge. We recommend solid state relays for applications where there will be frequent ON/OFF switching.

AP-x Series SSD(APS Photo Relays)用于充电・放电时的切换。
对于ON/OFF切换次数较多的用途,建议使用光电耦合器。

1.

Regular operation
Turn ON both solid state relays for charge and discharge control. Current flows in both directions.

一般情况下
充电・放电控制的光电耦合器均置ON。
双向均有电流流过

2.

p4.jpg

Over-charge prevention
In order to prevent over charging, the solid state relay on the charge control side turns OFF. On the discharge side, current will flow because there is a diode.

防止过充电
为防止过充电,充电控制侧的光电耦合器变为OFF。
由于放电侧有二极管,因此会有电流流过。

3.


Over-discharge prevention
In order to prevent over discharging, the solid state relay on the discharge control side turns OFF. On the charge side, current will flow because there is a diode.

防止过放电
为防止过放电,放电控制侧的光电耦合器变为OFF。
由于充电侧有二极管,因此会有电流流过。

Charge and discharge control is possible by effectively utilizing the internal diodes of the solid state relay.
有效利用光电耦合器内部的二极管,从而可对充电・放电进行控制。

p3.jpg


2. For preventing an inrush current into capacitors when charging (pre-charge circuit)防止充电时发生的电容冲击(预充电电路)

APx Series SSR (APSPhotoRelays), 10A and 20A types of relays are used for preventing an inrush current into capacitors when charging. We recommend solid state relays for miniaturization and 10A and 20A types of relays for high voltages.

AP-x Series SSD(APS Photo Relays)、10A、20A型继电器用来防止充电时电容产生的冲击电流。
要求小型的情况下,建议使用光电耦合器、高电压时为10A、20A型继电器

p4.jpg

During device startup, the inrush current prevention relay turns ON and the main relay turns ON after the capacitor is charged.
Effective for protection against inrush currents that occur when charging the capacitor.

启动机器时,用来防止冲击的继电器将会置ON,电容充电后,主继电器将会置ON。
对于电容充电时产生的冲击电流,可有效地发挥保护作用。

3.For Insulation Detection绝缘检测用途

APS Photo Relays are used for monitoring storage battery units for insulation deterioration. If the insulation in a unit deteriorates, a ground-fault current passes when the relay is turned ON, and a sensor detects the current. High load voltage type APS Photo Relays are ideal for use with storage batteries, which carry high voltage.

使用APS Photo Relays对蓄电池单元的绝缘劣化进行监控。单元内部发生绝缘劣化的情况下,置ON时将会有接地电流流过,传感器将会进行检测。由于蓄电池属于高电压,因此适合使用高耐压型APS Photo Relays

Inside of a storage battery unit

p5.jpg

When insulation of high voltage area and chassis is deteriorated

高电压部与底盘的绝缘发生劣化时

1. APS Photo Relays is turned on.

APS Photo RelaysON
2. The current sensor detects a ground-fault current.

电流传感器检测接地电流
3. An alarm signal is output.

警报信号的输出

4.For Battery Monitoring电池监控用途

APS Photo Relays are used in a circuit for monitoring charging voltages of a battery cell group. Compact APS Photo Relays capable of frequent switching are ideal for this type of use. Use of the relays allows for insulation from high voltage areas.

APS Photo Relays用作电池组(群)充电电压的监控电路。适合使用小型尺寸、可高频度开闭的APS Photo Relays。通过使用继电器,从而可与高电压部分实施绝缘。

When charging the capacitor

电容充电时

1,APS Photo Relays on the battery cell side are turned ON.

电池组的APS Photo Relays为ON

2,The capacitor is charged.

电容开始充电

p6.jpg

When measure

测量时

1.APS Photo Relays on the battery cell side are turned OFF.

电池组的APS Photo Relays为OFF

2. APS Photo Relays on the measurement side are turned ON.

测量的APS Photo Relays为ON

3. The voltage of capacitor(= voltage of battery cell group) is measured.

测量电容电压
 (=电池组(群)的电压)

p7.jpg


会员登录
登录
其他账号登录:
我的资料
留言
回到顶部